Пнеўматычны электрамагнітны клапан шырока выкарыстоўваецца ў нашай вытворчасці . Звычайна пнеўматычны электрамагнітны клапан: 3 порта 2 становішча, 4 порта 2 становішча, 5 порта 2, і інш.
(1) Пнеўматычны электрамагнітны электрамагнітны клапан друзлы або выключаны, пнеўматычны электрамагнітны клапан не падсілкоўваецца . Калі гэта адбудзецца, вы павінны праверыць лінію электрамагнітнага клапана і ўзмацніць праводку .
![]() | ![]() |
(2) The solenoid valve coil is burnt out, the wiring of the solenoid valve can be removed and measured with a multimeter. If the circuit is open, the solenoid valve coil is burnt out.The reason is that the coil is damp, causing bad insulation and magnetic leakage, resulting in the coil current is too large and burned out, so to prevent water into the Саленоідны клапан . Акрамя таго, спружына моцная, сіла рэакцыі занадта вялікая, павароты шпулькі занадта мала, адсмоктванне недастаткова можа таксама прымусіць шпульку спальвацца . У выпадку надзвычайнай сітуацыі ручной кнопкі на пнеўматычным электралагічным клапане можа працаваць, каб адкрыць пнеўматычны клапан {{5}
(3) Solenoid valve is stuck.Solenoid valve sleeve and spool with very small clearance (less than 0.008mm), is generally a single assembly, when there are mechanical impurities into or too little lubricating oil, it is easy to get stuck.The treatment method can be used from the head hole into the steel wire, so that it bounced back.The fundamental solution is to remove the solenoid valve, remove the spool and spool sleeve, with CCI4 cleaning, so that the spool in the valve sleeve action flexible.When disassembling, attention should be paid to the assembly sequence and external wiring position of each part, so as to reassemble and connect correctly, and check whether the oil spray hole is blocked and whether the Змазвае алей дастаткова.

.
![]() | ![]() |




